Perun P90 AEG Mosfet (Not Compatible with Krytac & G&G P90)

In Stock.
Out of Stock.
  • MOSFET For P90 AEG
  • Adjustable Trigger Sensitivity
  • Selectable Firing Modes
  • Active Brake
  • Precocking
  • Binary Trigger
  • Rate Of Fire Reduction
  • Low Battery Voltage Alarm
  • DSG
  • Diagnostic System
  • Electronic Fuse

*Perun P90 AEG Mosfet is incompatible with G&G and Krytac P90's*


Perun for the P90 replaces the trigger bar and mechanical contacts in your P90 replica and provides lots of useful features. Magnetic sensors coupled with a magnet installed directly on the trigger, allowing you to remove the bar that connects the trigger with the gearbox, making the trigger pull much smoother. The proprietary cut-off lever (which comes with the Mosfet) works with an optical sensor to eliminate all problems with a single fire function.

Replicas compatible with this mosfet are models made by: Tokyo Marui, ACM, Asia Tactical, Classic Army, Cybergun, CYMA, Double Bell, J Tactical, JG. King Arms? P90 and Novritsch's SSR90 are mostly compatible but require certain modifications.

*Perun P90 AEG Mosfet is incompatible with G&G and Krytac P90's*

The Perun for P90 Mosfet comes jam-packed with features such as:

Adjustable trigger sensitivity - The trigger can be set to 5 sensitivity levels, ranging from a very short pull needed to fire a shot, to a very long one. No modification to the trigger or the gearbox is needed and the trigger sensitivity change is possible even in the field.

Selectable firing modes - The user can choose firing modes available after the short or long pull of the trigger: SEMI ONLY, BINARY, SEMI-AUTO, SEMI-BURST, BURST-AUTO.

Active brake - active brake stops the motor after each shot preventing spring compression or in the case of replicas with a high rate of fire, overspin (double shot problem).

Precocking - Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With precocking enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot will be fired immediately after you pull the trigger. To release the spring after using precocking, pull the trigger and hold it for 2 seconds, after which a second shot will be fired, this time with no precocking and fully braked.

Binary trigger - Allows for easy double shots in a semi-automatic setting. After enabling this mode, if semi-automatic fire is set, shots will be fired not only when the trigger is pulled, but also when it is released.

Rate of fire reduction - Reduce the rate of fire in automatic or burst fire to save ammo or make the replica shoot in a more realistic fashion.

Low battery voltage alarm - Dedicated for Li-Po and Li-Ion batteries. Should the battery voltage fall to a dangerously low level, user will be notified by short sound signals that are repeated every minute. This may also be freely switched on and off.

DSG - a sector gear detection mode specially prepared to work with dual sector gears.

Diagnostic system - Constantly monitors the replica and the MOSFET itself. In case of any problems, immediately lets you know what it might be, making troubleshooting much easier.

Electronic fuse - This will save your replica and battery in case of a major malfunction. It will automatically disconnect the battery when a short circuit or blocked motor is detected.

Programming of all the settings is done solely by using quick and easily memorable sequences of fire selector switching and trigger pulls supported by sound signals and a multicolor LED diode. This allows changing the settings at any moment, in a matter of seconds, even under enemy fire. All settings are set independently for each selector position, so you can program the MOSFET exactly the way you want, for example, semi on semi and binary trigger on auto.

Perun P90 MOSFET works without problems with any battery from 7V to 17V. It can also be used with the most extreme setups.

*Perun P90 AEG Mosfet is incompatible with G&G and Krytac P90's*

Check out more Airsoft Upgrades


  • Tokyo Marui P90 Electric Airsoft gun
  • ACM P90 Electric Airsoft gun
  • Asia TacticalP90 Electric Airsoft gun
  • Classic Army P90 Electric Airsoft gun
  • Cybergun P90 Electric Airsoft gun
  • CYMA, P90 Electric Airsoft gun
  • Double Bell P90 Electric Airsoft gun
  • J TacticalP90 Electric Airsoft gun
  • JG P90 Electric Airsoft gun
  • King Arms? P90 Electric Airsoft gun
  • Novritsch?s SSR90 Electric Airsoft gun


  • x1 Perun P90 AEG Mosfet (Not Compatible with Krytac & G&G P90)
  • x1 Manual
  • x1 Stickers

Replica TypeSMG
Net Weight (kg)0.06
Length (mm)75.0
Content Included

Perun P90 AEG Mosfet (Not Compatible with Krytac & G&G P90)

Write Your Own Review
You're reviewing:Perun P90 AEG Mosfet (Not Compatible with Krytac & G&G P90)
Your Rating
Customer Questions
No Questions
Please, mind that only logged in users can submit questions

Customer Who Bought This Also Bought