MAXX Wolverine MTW M4 HPA Hop Up Chamber (CNC Aluminum)

The CNC Aluminum Hop-Up Chamber M4W unit by MAXX Model is expertly machined for precise and consistent performance with HPA MTW Milspec, Forged, Billet, and MTW-9 series rifles.

This unit features an aluminum rotary dial knob for fine hop-up adjustments, a precision hop-up lever, and 4mm bucking nubs, optimized for R-Hop and Standard-Hop setups to ensure accurate and consistent BB shooting with every shot. It is designed to accept the HPA MTW Engine M4 nozzle length and is fully compatible with most aftermarket soft and hard rubber buckings, maintaining FPS without dropping BBs.

Equipped with an interchangeable inlet adaptor (OD 11mm), the hop-up unit fits securely in the center of the 11mm inner bore of the HPA engine nozzle outlet, eliminating wobble. Additionally, it includes removable CNC brass side wings for smooth installation into outer barrel slots, along with a CNC Delrin locking C-clip to keep the inner barrel securely in place, preventing wobbling and twisting.

Check out more Airsoft Parts

Compatibility:

• For most HPA MTW Milspec, Forged, Billet and MTW-9 series rifles

Includes:

• 1 x CNC Aluminum Hopup Chamber M4W unit
• 2 x CNC Acrylic Side Cover
• 2 x CNC Brass 2.6mm Side Wing
• 1 x CNC Steel Pivot Pin
• 1 x CNC Aluminum Hopup Lever
• 1 x CNC Aluminum Soft Round Nub
• 1 x CNC Aluminum Soft Flat Nub (4mm)
• 1 x CNC Aluminum Hard Concave Nub (4mm)
• 3 x Steel Nub Spring
• 1 x CNC Steel Spring Guide
• 1 x Steel Upper Compression Spring
• 1 x Steel Center Compression Spring
• 1 x CNC Delrin Locking C-Clip
• 1 x CNC Brass Barrel Spacer
• 1 x Brass Barrel Spacer Holder Oring
• 1 x CNC Aluminum Rotary Dial Knob
• 1 x CNC Aluminum Inlet Adaptor (OD11mm)