MAXX Wolverine MTW Hop Up Chamber M4W (CNC Aluminum)

The CNC Aluminum Hop-up Chamber M4W unit is precisely machined to perform accurately and consistently on HPA MTW Milspec, Forged, Billet, and MTW-9 series.

The Hop-up Chamber M4W unit is built with an aluminum Rotary Dial Knob for fine hop-up adjustments, the precision Hop-up Lever and 4mm Bucking Nubs (6mm Bucking Nubs are optional) to perform best with R-Hop and Standard-Hop to keep the BB shooting accurately and consistently on every single shot.

The Hop-up Chamber M4W unit is designed to accept the HPA MTW Engine M4 nozzle length and is fully compatible with most aftermarket soft and hard rubber buckings without losing FPS or dropping BB during use.

The Hop-up Chamber M4W unit is wisely equipped with an interchangeable Inlet Adaptor OD11mm to ensure the hop-up unit is inserted exactly in the center of the 11mm inner bore HPA Engine nozzle outlet without wobbling. (Inlet Adaptor OD11.5mm and OD12mm are optional)

Also mounted the removable CNC Brass Side Wings to slide smoothly into the outer barrel slots, and included an advanced CNC Delrin Locking C-Clip to hold the inner barrel tight in place without wobbling and twisting.

Check out more Airsoft Accessories

Compatibility:

• Most HPA MTW Milspec, Forged, Billet, and MTW-9 Series
• Most Hop-Up Buckings

Includes:

• x1 CNC Aluminum Hop-Up Chamber M4W unit
• x2 CNC Acrylic Side Cover
• x2 CNC Brass 2.6mm Side Wing
• x1 CNC Steel Pivot Pin
• x1 CNC Aluminum Hop-Up Lever
• x1 CNC Aluminum Soft Round Nub
• x1 CNC Aluminum Soft Flat Nub (4mm)
• x1 CNC Aluminum Hard Concave Nub (4mm)
• x3 Steel Nub Spring
• x1 CNC Steel Spring Guide
• x1 Steel Upper Compression Spring
• x1 Steel Center Compression Spring
• x1 CNC Delrin Locking C-Clip
• x1 CNC Brass Barrel Spacer
• x1 Brass Barrel Spacer Holder O-ring
• x1 CNC Aluminum Rotary Dial Knob
• x1 CNC Aluminum Inlet Adaptor (OD11mm)