Angry Gun Tokyo Marui MWS GBBR Airsoft High Speed Bolt Carrier w/Gen2 MPA Nozzle-Original - FDE

Jojo

2023-04-24 23:35:42

Must Get!

I run indoor and outdoor fields where fps limits vary from 350 to 450 so I needed something that would allow me to adjust the pressure output short of buying high psi and low psi gas. This was one of the best investments I could make. The bcg is solid and is a nice brown clay color that goes well with the color of my mk18 furniture. It's sturdy, solid, and appears to be slightly lighter than the OEM bcg which would theoretically increase rate of fire. I dont use auto frequently but it's there when I do. Adjusting the nozzle is easy and requires a small allen key that you place directly into the nozzle outlet and rotate radially to increase or decrease expelled gas pressure, thus decreasing or increasing fps respectively. The nozzle so far has been stable and after a period of inactivity still remains at the pressure I set it at. After one session of about 22 matches, it still holds at the set pressure with a minor deviation due to mag temp. Paired with a great hopup, you will be able to hit targets reliably with heavier gram bb's without losing too much velocity especially with shorter cqb inner barrels. I run .25s and have it set to 355 with the initial shot as pressure normally decreases after each successive shot and no more cheaters that dont call their hits after using .28s. Save on the replacement nozzle spring for the oem nozzle along with the disassembly. Get this, swap out the oem bcg with this, and swap out the buffer spring and buffer and youre good to go!